If the anchor is already fully positioned behind the edge of the drywall, it may need to be pushed in and the hole patched rather than completely removed from the wall. The anchor can be pushed back with a screwdriver and some force.
The simple repair is to replace it with a larger conical anchor, but this anchor will also likely pull out over time. A more effective solution is to replace it with a plastic screw anchor, molly bolt, or toggle bolt. The last two anchor types clip against the back of the drywall for extra holding power.
Installing a Self-Drilling Threaded Anchor
Using a rubber mallet or mallet, lightly tap the anchor into the wall until you reach the threads. Using a screwdriver, screw the anchor into the wall until the head of the anchor is flush with the drywall. Again, if you choose to drill, go slow and be careful.
Related articles. Whether you are using a plastic wall anchor, molly screw, or other type of wall anchor, you will need to drill a hole in the wall, and the size of the hole is critical for the anchor to function properly. If it’s too small, the anchor won’t fit, and if the hole is too big, it won’t hold.
Screw holes in drywall can be reused when you install a stable mounting system. Repurpose holes in drywall with plastic anchors, toggle screws, and molly bolts.
You want the anchor to go in fairly smoothly with some resistance, but you don’t want to struggle with it going in. Hammer in the anchor until it is flush with the wall.
Screws or nails popping out of the wall indicate that the drywall is not properly attached to the frame in that area. Simply screwing or nailing the fasteners back into the wall will not solve the problem. Instead, you must install new fasteners in an undamaged area near the cracked fastener to secure the drywall.
Toggle screws are the types of drywall anchors that can support up to 50 pounds, while steel hollow wall anchors have a weight limit of up to 100 pounds.
Buy the right size
Since the purpose of a drywall anchor is to stabilize a screw, it must be at least one size larger than the screw. Since the size of the screws you need to use varies depending on the size and weight of the item being hung, the size of the wall anchor will of course also change.
< li>DO NOT make the hole wider than the anchor.
Once the drywall anchor and screw are removed, they can be reused. The drywall anchor and screw may require a larger hole during reinstallation on the second pass, and removing a drywall anchor that is not designed to be removed can potentially damage your wall or ceiling.
However, if you haven’t driven a screw very deep into the anchor, you can pull the screw out and reuse the anchor just by reinserting the tip of a screw. Grasp the screw with pliers and pull straight back. The dowel gets dusty, but still usable.