Contents
Cured product can be removed with a combination of soaking in a Loctite solvent and mechanical abrasion such as a wire brush.
Retention compounds are anaerobic and will set to a solid form when exposed to metal ions in the absence of air. Some bonding compounds are permanent, while others can be removed by heating.
Typical applications include locating pins in radiator assemblies, sleeves in pump housings and bearings in automotive transmissions. Curing time: Up to 72 hours, depending on the substrate used, the adhesive gap and the temperature.
LOCTITE® 620 is a joint compound for bonding cylindrical screw parts.
LOCTITE® red screw lock is the strongest screw lock. This product fully cures in 24 hours and is available in both liquid and semi-solid anaerobic forms. The red, high-strength screw locking products are so strong that they may require heat to disassemble.
Turbo Lock 17 fasteners (equivalent to Loctite 620) – ONE 50ml bottle.
To disassemble the Loctite 648 material, use heat of approximately 250 degrees Celsius and the material will disassemble. Cured material can be removed by soaking in Loctite solvent and using a wire brush.
LOCTITE joining compounds offer several advantages over traditional methods, thereby ensuring limitless strength for secure bearings and cylindrical parts.
Joint connections have a higher strength and were specially developed for bonding components. This is in contrast to threadlockers which are typically designed to prevent leakage, loosening and corrosion of threaded fasteners.
Yes, you can. We normally recommend fasteners such as LOCTITE 638 for such applications, but threadlockers and fasteners are chemically the same, i.e. they are anaerobic.
1. For best results clean all surfaces (exterior and interior) with LOCTITE® solvent and allow to dry. 2. If the material is an inactive metal or the cure speed is too slow, spray with Activator 7471™ or 7649™ and allow to dry.
Fixed cure time 10 minutes and full cure time 24 hours at a temperature of 77 degrees Fahrenheit.
Loctite® Bearing Mount 609™ connects cylindrical slip-fit or press-fit parts to prevent loosening. Excellent for holding bearings in place in housings or on shafts.
Joints are adhesives commonly used to fill gaps between various mechanical components. They help prevent deformation of these mechanical components by reducing wear and increasing the strength of the finished assembled product.
Latest Questions
© 2022 intecexpo.com
We use cookies to ensure that we give you the best experience on our website.