Unplug the Fedders AC. Press the reset button. Plug the device back in. Turn on the device.
Locate it on the outside of your machine first, especially along the bottom edge near the ground. An air conditioner’s reset button is usually red and visible, so it should be easy to spot. If you don’t see a reset button on the outside, it may be on the inside of the device behind the service panel.
Five easy steps to reset your air conditioner
Locate the breaker box in your home and turn the air conditioner breaker to the off position. Turn the breaker for the air conditioning to AC back on. Now wait 30 minutes. During this time, the internal circuit breaker in your air conditioner will reset.
After you turn the system back on, it takes a while for the air conditioner’s internal circuitry to reset. It usually takes about 30 minutes, so wait until then.
Resetting the thermostat
Common methods of resetting a thermostat include inserting the battery upside down for five seconds, pressing a recessed reset button with a needle or paper clip, or turning off the circuit breaker on the Thermostat for 30 seconds.
To reset the remote, remove the old batteries from your AC remote for 5 to 15 minutes. Then replace them with the same type of battery, usually AAA or AA. Your air conditioner remote control will be reset.
If your air conditioner is not working, there can be a number of reasons. Common reasons are dirty or clogged air filters. In other cases, there may be problems with your compressor or refrigerant. This can result in your air conditioner not blowing air, not turning on, or just not seeming to work properly.
Various problems with the thermostat can cause your air conditioner not to turn on. One of the most common problems is disconnected or loose wires. If the wires are frayed, disconnected, or dirty, your air conditioner will not turn on. Another common problem is a faulty thermostat.
The internal circuits of your air conditioner will take some time to reset after you turn it back on. This can take about half an hour, so sit tight for about 30 minutes. Turn your air conditioner back on at the thermostat.
If your air handling unit is running but not blowing air, there are two likely scenarios; Either a broken AC fan belt or a problem with the motor itself. If the air conditioner hums or hums but doesn’t make the mechanical sounds of a running engine, you are most likely talking about a problem with the engine itself.
If your air conditioner is blowing out warm air, your unit’s refrigerant level may be low. This usually indicates a refrigerant leak in your system! If that’s the case, your air conditioner will keep running, blowing out warm air to reach the temperature you set on your thermostat.
The purpose of the reset button
The reset button is designed to solve problems like this by resetting the thermostat. When you press the reset button, you reset your HVAC system’s thermostat. It will turn off completely and may reset to factory settings depending on the type of thermostat.